G-PLUSFender Flares, Fit 2007-2013 Chevy Silverado 1500/2007-2014 Silverado 2500HD 3500HD, 78.0"/97.6" Long Bed

Fit perfect

Don't even waste you time considering these. Directions incomplete and poor illustrations. Part did not even fit the vehicle advertised for, actually 1 inch too short, had to use spacers. Flairs do not conform to the body and stand away from the body. Instructions do not reference what mounting hardware is to used where but refers to "factory holes" which do not exist. Just to get the flairs fastened to the vehicle had to use hillbilly engineering, sheet metal screws, bolts, washers and nuts not included with package. It will be surprising if this junk survives a car wash. Total and complete TRASH.

I put these just on the front fender of my Silverado and they fit great! It took less than 3 minutes to install, and since this is screwed directly to the truck it fits nice and tight. I was considering squeezing some plastic binder or adhesive on the inside, but I don't think it is needed. The flare fits very well.

Price and delivery time was excellent for the flares, comes with plenty of hardware and instructions which was nice. However the rear flares did not properly fit and the drivers side ended up breaking during install. Fronts were easy to install at least. But now I’ll have to order another set because of the one broken flare and nobody carries a single flare.

They worked good for me.I self tapped a couple holes on the back two

Didn't look like they would fit on the rear. After installing the fit perfectly. Nice finish and quality compared to price. Small blemish from shipping but other wise would highly recommend over other more expensive brands.

The rubber trim does not stay on, and when you go to mount them , they won't sit flush against the body. So if you want a crappy, cheesy look on your truck, buy these.

The instructions were a bit confusing but just use common knowledge and they'll go on just fine. I have already lost one of the rubber strips, they need to have some kind of glue inside to help them stay on. My truck was starting to rust above the rear fender well and covered it perfectly and they don't stick out as far as a lot of the other ones do.

The four fender wheel moldings installation took about 2 1/2 hours with the most time consuming part being the removal of the original mud flaps. The seal around the fenders was excellent with the exception of a slight gap on the leading edge of the rear moldings. Also, with the removal of the front mud flaps, there is no longer a lot of protection of the doors. It is strongly recommended to order additional flexible mud flaps to protect the lower door sections

Very poor fitting product.