Eltako Radio Actuator Universal dimmer Switch 230 V. Power FUD61NPN-230V

• Sw devices, power supplies and electronic electricity meters.
• For building installation and control technology.

Universal dimmer switch, power MOSFET up to 300 W. Automatic lamp detection. Standby loss only 0.7 watts. Minimum brightness or dimming speed adjustable. With children's room, snooze and light alarm switch. Additionally with light scene control. Encrypted radio, bi-directional radio and repeater function can be switched on. For flush ing. 45 mm long, 55 mm wide, 33 mm deep. Universal dimmer switch for lamps up to 300 W, depending on the ventilation conditions. Dimmable energy-saving bulbs ESL and dimmable 230 V LED lamps additionally depending on the lamp electronics. Sw in zero passage with soft on and soft off for lamp protection. Supply, sw and control voltage locally 230 V. No minimum load required. The control of this dimmer switch is done with the wireless buttons FT and FFT, the wireless hand-held transmitters FHS and FMH as well as the remote controls FF8 and UFB. The set brightness level remains stored when switched off (memory). In the event of a power failure, the sw position and the brightness level are stored and may be switched on when the supply voltage is returned. Automatic electronic overload protection and over-temperature shutdown. From the manufacturing week 11/14, encrypted sensors can be learned. Bi-directional radio and/or repeater function can be switched on. Any change in state as well as received central control telegrams are then confirmed with a radio telegram. This wireless telegram can be learned into other actuators such as FSR61NP-230V, GFVS software and universal displays. The GFVS software also displays the current dimming value in %. With the top % lamp/dim speed rotary switch, either the minimum brightness (fully dimmed) or the dimming speed can be set. The lower rotary switch determines whether the automatic lamp detection should be effective or special comfort positions: Auto allows the dimming of all types of lamps. EC1 is a comfort position for energy saving lamps, which must be switched on with an increased voltage due to the construction so that they turn on again safely when dimmed. EC2 is a comfort position for energy-saving lamps, which cannot be switched on again due to the construction dimmed. Therefore, memory is switched off in this position. LC1 is a comfort position for LED lamps, which cannot be dimmed far enough on car (phase section) due to construction and therefore must be forced to phase control. LC2 and LC3 are comfort positions for LED bulbs such as LC1, but with other dimming curves. No inductive (wound) transformers must be used in EC1, EC2, LC1, LC2 and LC3 positions. In addition, the maximum number of dimmable LED lamps can be lower than in the car position. The buttons can be learned either as a direction button or as a universal button: turn on and dim on one side as a direction button, and switch off and off on the other side. A double click on the power side triggers automatic dimming to full brightness at dim-speed speed. A double click on the off side triggers the snooze switch. The children's room switch is run on the switch-on side. As a universal button, the direction is reversed by briefly releasing the button. Light scene control, light switch, children's room switch and snooze according to user manual (English language not guaranteed). The LED accompanies the learning process according to the operating instructions and displays radio control commands by brief flashing.