NXRRH3001 30" Professional Under Cabinet Range Hood, Stainless Steel

So far so good. I took my time and did clean job installing smooth metal ductwork. I also installed a good roof jack (FAMCO GN8) both which help with performance. Made a few calls to NXR with questions and they answered right away. We own a NXR stove (for five years now with zero problems) and did a lot of research before buying this vent hood. I saw some complaints about this hood in other reviews so let me give my personal thoughts on that. This hood is quiet. At least I think so. The instructions say to install 28 to 30 inches above the stove. Don't do that. After talking to NXR support, they recommended it goes around 34 - 36 inches above our NXR gas stove. I had just about 34 and it works great. I also heard some folks complain about shaking. Our copy is smooth. There is very (very) light shaking at high speed that is 90% gone now that the vent is screwed in place. This part is important!! If you have restrictions in the duct work, it will shake bad. I tested this when I was installing it by blocking off the duct with my hands and the unit will shake. Unblock it and it stops. Properly sized 8 inch ductwork thru-out the entire duct run is critical. The instructions state one damper. We are in a cold climate so I have two dampers in my setup. One is built into the roof jack. The other is inline about 1 foot above the vent hood (It's an Aldes). I called NXR support and they agreed that it was ok to use two dampers. I saw some complaints about the lights being dim and green. Ours are pretty bright and a fairly neutral white so no complaints there. The stainless finish looks good to me. It is NOT a Wolf or Vent-a-Hood quality finish but it looks really nice and matches my NXR stove. Overall, I like it. Paid $399 here on Amazon and it included free shipping so hard to beat. We'll see how it hold up over time.