PIDINGER 19PCS Paintless Dent Removal Tools Aluminum Auto Body Dent Repair Puller and Nylon Tab Set

Description

Lightweight T-Bar and puller weighs less than 6 oz. Hand held dent puller with T-Bar allows controlled, firm pulling action when repairing pressure dents and any dent that isn't sharp or creased. 18 tab adapter fits all glue pulling tabs. 1: Confirm dent frist,later use the Glue tabs Painted the Glue ,later put on the dent 2. use the red puller to pulling the glue tabs , untill dent restore level Note: If the above repair is not repaired successfully, please repeat the repair again 1:If the surface after repair has raised point, you can use the thumb presses the bump 2: use the use the thumb presses the bump also not have effect , you can try our store Dent Removal Pen ,if you need you can buy in our store ,thank you! USE STEPS: 1.Clean the surface of the drawing and dent with 95% alcohol. 2. Use a high performance glue gun and wait for 3 minutes after the power is plugged. The working temperature of the glue gun is about 165-200 degrees. 3. Select the size of the super connector according to your body sheet metal dip, and determine the size of the super connector at one time. 4. Use the heated glue gun to squeeze the super treatment evenly on the surface of the super connector, and place it in a quick and slightly hollow place, waiting for 50 seconds or 1 minute.Note: slight pressure cannot be applied in the recessed area. The super connector can be reused after cleaning. Do not discard it! 5. Using the puller, adjust the force slowly during operation according to your sag size until the sag is completely flattened and restored. 6. Spray the degumming agent at the super bonding point of the super connecting head and remove the film lightly and slightly to remove the residual super adhesive. Note: double check if the sag repeats steps 3-4-5. It is important that the sag is completely flattened. 7.Wipe the surface, and you can hardly see after repair.