OMNIBUS F7 Features: F7 MCU - faster than the current F3 and F4 processors Two gyros on the flight controller: an MPU6000 for sampling up to 8khz and ICM20608 for sampling up to 32khz Built in betaflight OSD 36x36mm, mount holes 30.5x30.5mm SD card reader for recording black box data (SD card not included) Supports 2-4s natively, 5-6s with 220uf 35V capacitor 5v/1A regulator Port for easy connection to Airbot 4-in-1 esc (SH1.0 8P) Package incl.: 1x FC
T**W
Buy three and 1 might be good.
Should come with a disclaimer saying:. Dear customer we are giving you 3 for price of 1. We couldnt give you plugs or even a manual. Good luck. Leds are bad, Osd is bad, 5v regulator is oscilating .400 mvThese open source controllers *shakes head*Doing AQL work is very much the key to not losing your ass. Dropshipped by the million pieces. This is the new swap meet. Amazon needs to adopt some quality control standards. Its gotten to be a 50% success rate at best.
P**R
Works great with betaflight and iNav
Works great with betaflight and iNav. Only problems:1. Right now all f7 boards are maxing cpu at 100% when 32k is turned in. I believe they are working on a fix.2. The little ribbon cable can pull out if you bump it wrong. It’s happened 3 times. Might need some hot glue to hold locking mechanism closed.3. Uart 7 doesn’t seem to have a Tx just a Rx.Works well otherwise.
V**J
Nice looking board but will not fly for a while.
I think it is a good board, unfortunately unless you downgrade the firmware to some ancient version like #132 or so, you will not be able to fly using DSHOT- none of them- well- yes Multishot works. Betaflight 3.1 and 3.2 has broken dshot for F7 board. So again, board itself may be good, but you will not be able to use it the way you should ( at least until Betaflight is fixed, so far nobody wants to touch it)
Trustpilot
2 weeks ago
3 weeks ago
