CURT 28930 Replacement Swivel Jack Female Pipe Mount

Thank you

Fits on my jack and keeps the jack from coming off!

Well made item that fit the Curt jack I bought perfectly. Problem is it doesn't come with a pin to hold it in place. The holes are for 1/2" pins which seemed a little light and poorly made. I drilled out the holes and put in 5/8" pins that work wonderfully and are easier to install and remove. Very happy with this item overall and the Curt jack too!

This pipe mount does fit my Toyota bottle jack that came with GX460. Diameter of my jack post is 1.5". This fits pretty well with 1/4" gap and it's not too loose. Feels steady and secure. Minus one star since it's bare metal and already came with some surface rust. Not a big deal though.

Works great easy to install ( but you will need a welder)

The description is not too clear about this. The pin holes are 9/16" (not 1/2" as some have said, and not the more standard 5/8").The description says this is for Curt 28931 or 28932 pipes. This is not correct, as only 28931 has 9/16" holes. The Curt 28932 has 5/8" holes, so that will be sloppy and perhaps dangerous.The tolerance between this female jack pipe and the male trailer pipe is looser than I am used to, but it firms up once you put the pin in.I bought 4 of these for a platform trailer (that becomes a stage). I had to re-machine them all to 5/8" holes so that I could use the male 28932 pipes that I bought with them. The original holes are not well machined. A couple of them were slightly off-center (still usable, but I would expect better). I am almost glad I had to re-drill all the holes, as now they are perfectly aligned.I think that covers the cons of this item.The pros are:This is heavy duty with almost 1/4" wall thickness for the pipe and bracket/channel.This comes raw, so you just need to hit it with a rotary wire brush a bit, and you are ready-to-weld. Some other brands come painted for unknown reasons.It has two little 1/8" holes where you can insert a cotter pin and attached your pin's keeper chain.

Bought this as a much cheaper alternative than the Bottle Jack Buddy. You can see I bent the two sides out by simply putting the one side down in a vice and using a big crowbar to lift up on the other side. Repeat for the other side. Anyone can figure it out with a half a brain. Works great. Fits perfect on a harbor freight bottle jack.

The measurements reported were what was received.

Perfect thank you.

Comes pre-rusted.And the holes are too small for a typical pin.If you have access to a sandblasting box and a drill press you can make it work, but cheaper to just buy a pice of pipe !!!