HD SwitchStarter Ignition Key Switch fits Ford New Holland Tractor 1000 1100 1110 1200 1210 1215 1220 1300 1320 1320 1500 1510 1520 1600 1620 1700 1710 1715 1900 1910 1920 1925 2110 2120 SBA385200331

It fits perfectly NH 2120 tractor. Looks very nice, has a plate which fits on the external part and which indicates which position of the key does what. Beyond master key it comes with two spare keys. Looks very nice and solidly built (very smooth key turning and nice spring return from either cranking mode or glow plug mode.If I could I would give a half star lower rating because the schematic showing the pins is not accurate, it doesn’t show which pin needs to be connected to the starter solenoid. Plus the language is not correct, for example the tractor glow plug don’t have resister (as it is shown on the picture of the pins) but they have resistor.

This is not advertised as an OEM replacement, but it should be - it was exactly like the Ford switch on my Ford 1620 diesel tractor. Even the numbers embossed near the terminals on the back side match the numbers on my broken original equipment switch. Plus, I learned something new when I looked at the new key position label that came with it). The product description is a little vague, and they didn't even include a picture of the terminals, so let me tell you what you get: This is a switch for a diesel tractor, with a position to the left to energize the glow plugs, then off, then run, then start (the key springs back from start to run when you release it, and it springs back from glow plugs to off when you release it from that position). On the back side, there are 5 terminals. Two have skinny screws and the other 3 have fat screws. I moved the wires from the old switch to this one, then put the protective boots in place, and my tractor fired right up, my dash lights worked, and (I'm embarrassed to say) that I hadn't even realized that turning the key to the left powers the glow plugs, but when I saw that written on the new label plate, I gave it a shot and found my tractor fires right up when I use the glow plugs the way they were meant to be used. Buy with confidence if you are looking for an ignition switch for your Ford diesel tractor.

On a ford 1320 this will start and operate the tractor. However, the oem switch had a nub that fits into the frame out to keep the ignition switch from turning in the frame. This does not have that.Other after market switches ship with an adapter ring that fits into the notch in the frame and the cutout on the aftermarket switch to keep it in place, but this one does not.So you will need to glue in place or figure out another solution.

Easy to replace and worked perfectly on my Ford 1300 diesel.

Would be 0 stars but not an optipn so get 1 star for quick delivery. Worked fine until ot didn't... Switch failed after mínimas use and I would like a replacement.

Exact replacement for original switch. Easy to install.

Purchased for my backhoe nice switch HD ,, but had to ohm out connections on switch.. Kind of a pain in the rear..

This switched was installed on a1983 Ford 1210 diesel tractor. The switch includes the position needed to warm glow plugs. 5 terminals. I would recommend taking a picture of the wiring on the old switch for reference purposes. So far, so good.