Need Small Fold Down Table Wall Mounted Heavy Duty Small Folding Wall Table Length 30 inches Width 20 inches Perfect Addition to Laundry Room/Home Bar/Kitchen & Dining Room AC15BB(7650)

*UPDATE* Seller offered to refund for the whole price. I appreciate that they reached out so I'm going to bump up my rating. The table is still holding well so there's no issue there. Hopefully they will fix the quality on the screws so this won't happen to anyone else. Other than that I like everything about the product.PAST REVIEW: Went to install the product and pre-drilled the holes for it but two of the screws broke right at the head. Luckily we had others at home that were better quality to replace them but now we have two broken screws stuck in our wall. As for the actual table it seems to be holding up well with a decent amount of weight on it but time will tell if it lasts.

I wanted this for folding clothes in the laundry. It works great. super sturdy. Exactly like pictured on Amazon. Needed more instructions and reached out to seller to sent me all kinds of information. Highly worth the money.

Really a hassle to install if you dont know what you're doing. You have to mount the brakes on the countertop manually as there are no predrilled holes. I am assuming that is to allow for different lengths in between studs. My particular installation area was difficult to determine where the studs where and after about an hour and a half of evaluation I choose to abort and return the item. Yes it's my fault for not identifying where my studs were but I didn't want to drill tons of holes in my wall to find them. I did use a stud finder but wasn't confident enough to actually drill.

I use it in my small laundry room as a folding table. It works amazingly.

My apartment lacks counterspace, so this was looked at as an alternative. I have a dog kennel in the corner of the kitchen so this was installed above it. As other reviews have said, the screws provided are absolute garbage. I broke three of them trying to attach the brackets to the wall.The instructions aren't great either, but it's just two brackets and a slab of wood. Here's what you need to know:1) Buy new screws. I used size 6, 2 inch screws. Picked up 8 of them at the local hardware store for $0.20.2) Install this into studs. It comes with drywall achors but don't kid yourself. There's good weight to just the slab. Use a stud finder and center it up.3) I found using a laser level the easiest. Set the level and use the stud finder to mark it off at desired height (I went with counter height).4) Pre-drill holes into the wall studs for the brackets. Start at the top. Using your laser level, you can make sure these are straight up and down. Secure the top ones first, then line up with laser, then drill your lower holes.5) Once both brackets are up, put the slab on top. Slide it all the way against the wall. Then measure from either side of the bracket (close to the wall) to the edge of the slab on both sides to center it. Do the same measurements from the bracket to the edge on the edge opposite the wall (to ensure they are straight).6) Pre-drill holes from the bottom. Start closest to the wall. Then had tighten the screws thru the holes with the provided short screws. They seem to work fine for this part.And done! Enjoy the new shelf.

Where’s the product support?!I should have known better when I saw the poorly written directions. Then multiple screws failed (3 going into the studs broke off, I should have switched to my own screws after 1). Just when I think I’m finally done, it won’t close flush. Making matters worse, the spring hinges keep popping out of alignment as it goes up and down. Obviously I did not install correctly, as our walls just are not plumb and this contraption is unforgiving. As I am trying to find product support (of which there is none) another screw fails - this time one of the smaller screws attaching the hinges to the actual desk - so much for that 200 lbs.I wanted to make my own, but we decided on this overpriced contraption because it was “highly rated” so it would be “easier.” I’m so frustrated. Now I have to take it all down, patch it all up, and start over MAKING MY OWN.

It states to put it on wood studs or concrete/brick. Where I wanted it did not have any of this. Just drywall (thick drywall) . My brother is a carpenter and he added the plastic drywall securing things and added a stronger one to the third bigger hole that was there but of no use in the instructions. That secured it very well to the wall and it’s working great. If that changes I’ll be sure to update.

As part of recent remodel, I removed a second slider to my Carolina Room and closed the wall. To add an element of more entertaining and seating, I had contractor add this folding table to the newly-closed wall. Perfect addition with the two bar stools for seating. I keep the table folded down unless in use, which adds to the flexibility of the use of this product. I would recommend this purchase.