RUPSE2pcs License Plate Light,12V Waterproof LED Bulb,License Tag Screw Bolt Lamp for Car Motorcycle Truck RV ATV Bike (White)

Great product! Changed the stock bumper on my '23 Rubicon that didn't have tag lights or a place to really install then without drilling into the new bumper. These acting as both lights and bolts were the perfect solution. Would have been much better if they were plug and play so I didn't have to cut the factory harness off.

Great!!!

Wires a little thin but worked just fine.

Nice

Pretty good they light is kinda dim but I guess that's good for what it's for

My recent led "upgrades" have all been pretty disappointing. This set of lights renewed my faith that there are some products out there worth the time though.The bad...The wire is thin (like 22/24 gauge), which is fine for the led, but it makes hooking them up a little bit of a PITA. They have a bit of exposed wire when you get them that you may be lucky enough to just crimp your connector on to. I however ended up snipping the end off and stripping enough insulation so that I could bend the wire over on itself in the crimp connector (doubling it).More bad...CHECK THE COATING ON THE LED CHIP. One of mine was not great, and water would have gotten in. I just used a wire tie to brush a tiny bit of silicone in the gap to protect against water getting in there.Neither of these issues were a big deal though really.The good...I'm happy with the light output for a change and light actually does make to bike stand out a bit more at night.Also, they actually have metal threads... So I was able to torque the bolts down through my plate frame with confidence.Overall, I'm very happy with them. I would rate 5 stars if they didn't need that little bit of finessing. So happy, that I'm going to try a set of their turn signals too after my next inspection.

I went four stars for wiring guage.I installed these on a custom license plate bracket that I made (I do recommend some blue thread lock). I've hade then on for a few months and that have been through some wet weather and still function fine and have no rust on them.They are bright enough to light up the license plate (as you can see in the picture, that is in a parking garage at about 2 in the afternoon) and I like the color temperature of the leds. They were easy to install and had plenty of wire to (I had to trim it) to reach to my splice location. As someone else said, plan on using some sort of wire connector or quick disconnect for them because if you splice them straight in, you will not be able to remove your license plate with out cutting the wires.I only have two issues, one of which was my fault. 1) the wiring guage is pretty small. A heavier guage would have been preferred. 2) the way I installed then the wire that comes out of the threaded extension was rubbing in the fender frame causing the thin guage wire coating to get cut/worn exposing the wire. Again this is not the sellers fault by my installation. My remedy was to fill the end of the thread hole with some liquid electrical tape and zip tie some rubber bushings behind the license plate bracket to keep it from rubbing.

I installed these on my sportster since I have an aftermarket license plate frame. They are very bright and light up the back of my bike very nicely, I could have gotten away with just one if i wanted to. There's one design flaw, and it could be a big one depending on the type of bracket you have. In order get your license plate off, you would have to unscrew the lights and cut the wire. You wouldn't think it would be that big of a deal but normally when wiring these up you want to conceal the wires and tuck them behind something so they aren't seen. So they're stretched pretty tight, once you cut them, you would have to rewire them completely. Now you could drill separate holes on the bracket so you wouldn't have to remove them completely to remove your plate, but my setup didn't have the room. It would be nice if these came with some sort of plug or male/female connector. I'm pretty good with a solder gun so I just added them myself.All that being said, I love these little things and I think if you plan your attack wisely you won't have any trouble at all.

Looks good and makes me legal. Easy to install work grate

Very bright

Very noce