Ucreative 3.2FT ID 5/8" (16mm) Reinforced High Temperature Silicone Vacuum Tubing Hose 200PSI Max Pressure Black

I used this to reroute the breather vent from on top of my rear differential to behind the driver side tail light on a 2001 Tacoma TRD. Originally the breather directly threaded into the top of the rear differential making it susceptible to water. I used this tubing in combination with a Dorman nipples breather valve and a threaded nipple on top of the differential to complete the rerouting. Worked perfectly!

Tubing looks good a should last much longer than the old rubber lines

Needed to replaced some old vacuum line on a an egr for 1994 gmc 1500 and it fit perfectly and have extra left over.

just what i needed for my wind shield washer

I used this not as an actual tube, but as an external frame on a piece of sheet metal I cut. Difficult to glue because it is silicone, but if you get some silicone instant glue it works okay, and looked great. The diameter is almost perfect for holding onto thin sheet metal if you make a slice to the center down the length.

Good hose

The ID is 3mm and the OD is 9mm. I was hoping for only 2mm OD but this is ok. A few days earlier I ordered the blue color but the order was "undeliverable" (to an Amazon locker). Not sure why blue is undeliverable but red is deliverable.

Worked perfectly. MUCH better (and easier) than the Nylock mod.

El producto cumple con lo ofrecido